1/8 Scale Nitro On-Road Car MRX6 

>> MRX6 Picture <<

The World Championship Mugen design team took their time and created a car that will have ultimate traction, great steering, impressive braking and molded into a car that will win in the hands of the pro racer to the club racer, a true work of art.
MRX6 features:
- Chassis:  
The MRX6 features a new narrow chassis that allows you to easily adjust the weight of the car by
using (up to five) H2412 weights in the center line of the chassis.  You're also able to adjust the
weight balance of the car by moving the weights forward or back on the chassis.  The new narrow
chassis is also stiffer and makes the vehicle more precise and predictable.
- Flex System:
The new advanced flex system allows the fuel tank and upper deck to flex separate from the  
chassis.  With the MRX6, the engine and exhaust system is mounted to the chassis and not to the
radio tray.  This is allows the radio tray and chassis to flex independently.
- Bulkheads:
The MRX6 has new front/rear bulkhead to allow for easy belt replacement.
- 2 Speed:
The new two-speed gear box is smaller, lighter and provides better acceleration from corner to
top speed.
- Suspension:
The MRX6 has new rear suspension geometry that greatly improves traction and cornering.
The rear of the vehicle is more controllable and predictable.
- Materials:
The MRX6 uses new materials for the rear lower arm and rear upright.
The new material is stiffer with improves durability and traction.
- Servo Saver:
The new servo saver allows for easy adjustment and more precise steering.
- Brake System:
The new brake system allows for easy adjustment and stronger braking force.
- Clutch Bell:
The new clutch bell has an improved plating process that allows better response and longer wear
for the clutch shoe.  It also helps improve the acceleration of the vehicle.
- Fuel Tank:
The fuel tank for the MRX6 is new and has a lower center of gravity.  The tank also features a new
cap which allows easy re-fueling during pit stops.  Another new feature with the fuel tank is you
can adjust the height of the fuel tank by using H0181 (H0181 isn't included in the kit).
- F/R Drive Shafts:
The F/R aluminum axle shafts are now included in the kit to provide better acceleration.
- Other upgrades:
New side belt tensioner, new rear body mount with centering system, and new adjustable front
upper arm.
Technical Data:
- Length: 441.6mm
- Width: 262mm
- Wheel Base: 299mm
- Tread (F/R): 216mm / 202mm
- F. Caster Angle: 8.5~15.5 adjustable
- Gear Ratio: 1st. 7.35:1 / 2nd. 5.52:1
Download:

Parts List 6.06MB
Kit bag details
1.63MB
Setup Sheet
351KB
Instruction Manual
 18.7MB

Other necessary equipment:
2ch Radio and 2 servos / Receiver / Connecting Cable / Receiver Battery / 21 Class Rear Exhaust Engine / Muffler / Manifold / Manifold Spring / Tire & Wheel  / Air Filter / Engine Starter / Body & Body paint tools / Fuel
Note:
The lead-detachable Servo from Sanwa cannot be used for the throttle/brake (can be used for the steering).
Require longer battery lead wire 150mm (Not include the connector).
You will find how to install Sanwa Built-in antenna receiver (RX-481, 482) to prevent any electrical interference. Click HERE for more information.
*The contents are subject to change without notice due to product improvements and specification changes.
*Final production version of product may and will differ from appearance of product shown on this web page.

Copyright © 2016 Mugen Seiki Co., Ltd. All rights reserved.